January 16, 2013

January 16, 2013 JEGE Inc. 14800 Northwest 42id Avenue Hangar 49 3800 Southern Blvd. Suite 110, Miami Florida, 33054 West Palm Beach, FL. 33406 Ph Fax www.aironetnaintenance.com FAA CRSN 3AORS18B Maintenance Contract Exhibit A Revision 1 Air One Maintenance & Engineering is pleased to offer this quote for the workscope requested for JEGE Inc.'s Boeing 727-100 VIP with registration number N908JE and Serial Number 20115 as follows: A) Accomplish "IA" & "2A", Check per Task Cards identified on Tally Flat Rate Routine & Non-Routine Labor B) Accomplish repetitive Airworthiness Directive inspections as listed in the work package: 1) AD88-22-09 - Operational and Functional Check of the Takeoff Warning System 2) AD91-06-06 — Fuselage Skin Lap Joints Inspection 3) Al:391-24-11R' — BS 870 Terminal Fitting Inspection 4) AD92-06-14 — BS 950 Side Fitting Inspection 5) AD2001-20-09 Pam (e) LMLG Fwd Trunnion Bearing Support Ftg. Replacement 6) AD2001-20-09 Pam (e) — RMLG Fwd Trunnion Bearing Support Ftg. Replacement 7) AD2004-18-08 Pam (e) — LMLG Forward Trunnion Attach Fitting Replacement 8) AD2004-18-08 Pare (e) — RMLG Forward Trunnion Attach Fitting Replacement 9) AD2005-21-01 — No. 1 and No. 3 Engine Temperature Indicators Inspection 10) AD2006-07-17 — Left Wing Front Spar Terminal Fitting Inspection 11) AD2006-07-17 — Left Wing Rear Spar Terminal Fitting Inspection 12) AD2006-07-17 — Right Wing Front Spar Terminal Fitting inspection 13) AD2006-07-17 — Right wing Rear Spar Terminal Fitting Inspection 14) AD2006-13-16 Pam (gX2) — Outboard Aileron Balance Tab Lubrication 15) AD2008-22-12 — Elevator Quadrant Upper Support Assembly Inspection 16) AD2009-20-08 — Operational Test of the Engine Fuel Suction Feed Flat Rate Routine Labor EFTA01112865 C) Accomplish Time Control Task Cards as listed in work package: 1) Zone 1 area 00 Lower Lobe 3 Year Inspection Open up 2) Pneumatic Brake Bottle Hydrostatic Test 3) Number 1 Main Oxygen Bottle Hydrostatic Test (crew) 4) Number 2 Main Oxygen Bottle Hydrostatic Test (Fwd Pax) 5) Number 3 Main Oxygen Bottle Hydrostatic Test (Aft Pax) 6) No. 1 Main Aircraft Battery Restoration (Main) 7) No. 2 Main Aircraft Battery Restoration (Aux) 8) Forward Auxiliary Fuel Tanks 3 Year Inspection 9) Fuselage Lower Lobe BS 480 to BS 680 3 Year Inspection I 0) Fuselage Lower Lobe BS 680 to BS 740 3 Year Inspection I1) Aft Auxiliary Fuel Tanks 3 Year Inspection 12) CVR ULB Battery Replacement 13) Fuselage Lower Lobe BS 950 to BS 1183 3 Year Inspection 14) Life Vest Restoration (crew set) 15) Life Vest Restoration (Pax sct) 16) Escape Slide Restoration (Fwd Entry Door) 17) Frew. Slide Restoration (Mid Cabin Door) 18) Portable Water Fire Bottle Restoration (fwd) 19) Portable Water Fire Bottle Restoration (Aft) 20) Artex ELT Battery Replacement 21) FDR Operational and Functional Check 22) Zone 1 Area 00 Lower Lobe 3 Year Inspection Close-up flat Rate Routine Labor The above maintenance items can be accomplished for a Labor Flat Rate of S 251,470.00 US. Any Non- Routines generated by the above routine maintenance items A will have a 5 man-how cap per item. Any additional non- routine maintenance items will be considered as over and above and will require approval by an authorized JEGE representative prior to being worked. Aircraft will be ready for re-delivery approximately 30 calendar days after induction. Air One Maintenance shall procure, on JEGE's behalf, all expendable parts, materials, etc. up to cost of $ 250.00 US each. JEGE is responsible to provide or authorize for purchase all parts, kits, materials, etc. that are quoted above a cost of $ 250.00 US. Both Air One Maintenance and JEGE must strive to maintain a Lead-Time not to exceed 48 hours from the time the purchase requisition is placed to the time delivery is made to Air One's facility. JEGE retains the privilege to have Air One procure any parts, materials, etc. that are mutually agreed to on its behalf; upon written approval by a JEGE authorized maintenance representative. Supplemental parts and material deposits may be required as purchases made on customers' behalf reach $ 25,000.00 increments. EFTA01112866 Additional Work "TM"; Cost Schedule Any additional Over & Above, non-routine or JEGE request items will be billed at $45.00 per man-hour mechanical and $48.00 an hour for avionics, plus materials. Overtime rates, if applicable and approved, would be at 1.25 times the standard rate. Additional work (if any) must be approved by your company representative prior to being worked. Composite / NDT repair work is an outside service and will be quoted separately. Cosmetic exterior or interior paint is excluded in this quote and will be quoted separately if required. In the event any outside contractor(s) are hired by WOE, not previously arranged & agreed upon by WOE and Air One, and Air One is not given the opportunity to provide the maintenance or modification, WOE will be charged for facility usage at a rate of 20% of the contractor's invoice to customer. JEGE would be responsible to provide Air One with an accurate invoice after work completion. All Fuel tank routine access, cleaning, inspection and repair, if required, and closing are considered as an over and above outside service and will be contracted through Air One. Any in-house Engineering will be billed at S 125.00 per hour. 1) Additional Charges Outside Plus 15% Exchanges -Cost Plus 15% Materials, Parts, Etc. —Cost Plus 15% Shipping /Freight -Cost Plus 15% 2) Payment 40 % of Flat Rate at Induction 20 % of Flat Rate atter 14 days 20 % of Flat Rate after 21 days Balance of Flat Rate and all of Over & Above / parts charges at delivery Air One Maintenance & Engineering looks forward to hopefully being of service to WOE Inc. If we m y be of further assistance or if you have any questions please do not hesitate to contact me at Tel. or Fax All services offered on this quote, upon acceptance, are subject to the terms and conditions of the Air One Maintenance & Engineering General Tents Agreement, which is incorporated herein by reference. With your acceptance signature, this document shall become a binding contract for the services offered above. Please list the person(s) or company who will be acting as your technical representative who will be authorized to act on your behalf to approve material purchases, over & above items and any changes to the workscope: Rep. 1. Rep. 2. Sincerely, VincentK Quinn President - CEO 3 EFTA01112867 N908JE Revision I Mr One Maintenance & Engineering, LLC. JEGE Inc. Agreed & Accepted Agreed & Accepted Si Name: Title: recij Date: / -16 - ) ° /3 Sign: Name: Title: Date: EFTA01112868