EFTA02456555

From: jeffrey E. <[email protected]> Sent: Monday, July 18, 2016 3:31 PM To: Lvjet Subject: Re: GIV update my fault On Mon, Jul 18, 2016 at 11:19 AM, Lvjet &g=; wrote: Jeffrey, I checked my old emails for Friday, I never received your email to go =ome,. I just received this email today at 11:03am July 18th to Go Home =A0 . for some reason, it just arrived in my inbox. island internet delivery delay, sorry,. I should have double checked with you on Friday, I thought you=said, didn't feel well when we arrived and you wanted us to remain on =TT., I'll always double check in the future, if there is a question in =egards to going home,. thx Larry -riginal Message From: jeffrey E. <[email protected] <mailto:[email protected]» To: Lvjet Sent: Mon, Jul 18, 2016 11:03 am Subject: Re: GIV update ok then , go home, On Fri, Jul 15, 2016 at 10:51 AM, Lvjet > wrote: Jeffrey I spoke to Tech ops, John and Mike,. Normal PSI in Duct pressure at FL450 (45,000') is 19 to 22psi, it =aries with Density Altitude and Temperature slightly. Mike indicated that Gulfstream does not like the term "Buffet&quo=; or "Vibration" they use the term "TRIM Variance" 4 1/40 if the exhausted air from pylon precooler air modulation valve w=s not equal to both L/H and R/H the air is disrupted over the tail section=of the aircraft Causing a TRIM VARIANCE. I informed Mike that we had to change the Gasket on L/H anticipator an= found a Loose Temp sensor in Left Pylon, and we changed the R/H pylon Ant=ciptor gasket as a precautionary measure. EFTA_R1_01559878 EFTA02456555 Now that Bleed system Duct pressure is tight and equal, Mike feels the=aircraft is operating at factory specs, Depending on pressurization Bleed system requirements, the Duct pressu=e will vary when 12th stage bleed valve opens for decent. during climb the=duct pressure can read as high as 40psi, since the HP Bleed valve located =n each engine is set to modulate exhausted air at 40PSI max into the cabin=. if air was blowing by the Anticipator gasket, this effects the amount =f air into the cabin, since the Anticipator is anticipating the 400 degree=air, and adjust the HP regulator valve accordingly. We have changed Both HP Regulator valves about a year ago,. so they ar= good on both engines. Equal temps and PSI on the panel in Radio rack are important informati=n, for smooth ops. thx Larry please note The information contained in this communication is confidential, may be attorney-client privileged, may constitute inside information, and is intended only for the use of the addressee. It is the property of JEE Unauthorized use, disclosure or copying of this communication or any part thereof is strictly prohibited and may be unlawful. If you have received this communication in error, please notify us immediately by return e-mail or by e-mail to jeevacation@gmailcom <mailto:[email protected]> , and destroy this communication and all copies thereof, including all attachments. copyright -all rights reserved =C2 please note The information co=tained in this communication is confidential, may be attorney-client pr=vileged, may constitute inside information, and is intended only for JEE Unauthorized use= disclosure or copying of this communication or any part thereof is str=ctly prohibited and may be unlawful. If you have received this commu=ication in error, please notify us immediately by return e-mail or by e=mail to [email protected] <mailto:[email protected]> , and destroy this communication and all copies thereo=, including all attachments. copyright -all rights reserved 2 EFTA_R1_01559879 EFTA02456556 </=iv> 3 EFTA_R1_01559880 EFTA02456557